Skip to main content

Removing an advanced management module

You can remove the advanced management module while the BladeCenter S system is powered on. To remove it, disconnect all cables, open the release handle, and slide the advanced management module out of the BladeCenter S chassis.

If the advanced management module that is currently installed in theBladeCenter S chassis is functioning, make sure that the configuration file has been saved before replacing the BladeCenter S Types 7779 and 8886.

See the Advanced Management Module User’s Guide or the Advanced Management Module Command-Line Interface Reference Guide for instructions for saving and restoring a configuration file.

Graphic illustrating the removal of an advanced management module from the BladeCenter S chassis

  1. Disconnect all cables from the advanced management module.
  2. Open the release handle (rotate the handle down) to disengage the advanced management module from the BladeCenter S chassis.
  3. Slide the advanced management module out of the BladeCenter S chassis.
    Note
    When you remove the advanced management module, the fan modules will begin to run at full speed.
Related information: