Removing an I/O module

You can remove an I/O module while the BladeCenter S system is powered on. To remove it, disconnect all cables, open the release handle, and slide the module out of the BladeCenter S chassis.

Important

If you are removing one or both SAS RAID controller modules from a BladeCenter S chassis, refer to the BladeCenter S SAS RAID Controller Module Installation and User's Guide for additional steps that might need to be performed.

1. Disconnect all cables from the module.
2. Open the release handle (rotate the handle down) to disengage the I/O module from the BladeCenter S chassis.
3. Slide the module out of the I/O module bay.