Install a rear I/O module
Follow instructions in this section to install a rear I/O module.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.
Touch the static-protective package that contains the component to any unpainted metal surface on the node and chassis; then, take the component out of the package and place it on a static-protective surface.
Procedure
- Install the rear I/O module to the node.
Align the screw holes on the rear I/O module with the screw holes on the bottom of the node; then, lower the rear I/O module and slightly push it toward the rear into place.
Tighten the three screws as illustrated to secure the rear I/O module.NoteMake sure that the standoffs are securely seated in the holes of the rear I/O module as illustrated.
Figure 1. Installation of the rear I/O module
- Reconnect the cables to the rear I/O module.
- Route and connect the cable between the rear I/O module and the system board (see Rear I/O and OCP module cable routing).
- Secure the grounding cable onto the rear I/O module standoff with a screw as illustrated.
Figure 2. Installation of the rear I/O cable and grounding cable
After you finish
If necessary, reinstall the PCIe riser assembly to the node and reconnect the required PCIe cables to the system board (see Install a PCIe riser assembly and Internal cable routing).
- If necessary, reinstall the GPU air duct (see Install a GPU air duct).
- Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover (see Install the top cover).
- Reinstall the node into the chassis (see Install a node to the chassis).
- Make sure that the required power supply units are installed and power cords are connected; then, power on the node (see Install a hot-swap power supply and Power on the node).
- Proceed to complete the parts replacement (see Complete the parts replacement).
Demo video