Skip to main content

Remove the power bus bar

Follow instructions in this section to remove the power bus bar.

About this task

To avoid potential danger, make sure to read and follow the safety information.

Attention

Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

Procedure

  1. Make preparations for this task.
    1. Power off the node (see Power off the node); then, disconnect all external cables from the node.
      Note
      If necessary, press the release clip with a flat-head screwdriver to remove an external network cable from the rear of a 2U node.

    2. Remove the node from the chassis (see Remove a node from the chassis); then, carefully lay the node on a flat, static-protective surface, orienting the node with the front toward you.
      Note
      • When removing the node, note the node tray number and make sure to install the node in the same tray from which it was removed. Reinstalling the node into a different tray requires the node to be reconfigured.
      • For safety, make sure to hold the node with both hands when lifting the node.
    3. Remove the top cover (see Remove the top cover).
    4. If the GPU air duct is installed in the node, remove it (see Remove the GPU air duct).
    5. If the internal adapter bracket is installed, disconnect all the cables from the internal adapter; then, remove the internal adapter bracket from the node (see Remove the internal adapter bracket).
    6. Disconnect all the fan cables from the system board; then, remove the fan cage from the node (see Remove the fan cage).
    7. If the PCIe riser assembly is installed, remove it from the node and disconnect the PCIe cables from the system board (see Remove the PCIe riser assembly and PCIe riser cable routing).
  2. Remove the six outer screws from the power bus bar.
    Figure 1. Removal of outer screws of the power bus bar
    Removal of outer screws of the power bus bar
  3. Remove the power bus bar.
    1. Remove the main PDB screw from the power bus bar.
    2. Remove the main system board screw from the power bus bar.
    3. Lift the power bus bar out of the node.
      Figure 2. Removal of the power bus bar
      Removal of the power bus bar

After you finish

  1. Install a replacement unit (see Install a power bus bar).
  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.