Skip to main content

Install a keylock switch with cable

Follow instructions in this section to install a keylock switch with cable.

About this task

To avoid potential danger, make sure to read and follow the safety information.

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
  • Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the node; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Make preparations for this task.
    1. If necessary, install the keylock switch cable to the bracket.
      1. Insert the keylock switch with cable into the bracket until it clicks into place.

      Figure 1. Installation of the keylock switch with cable onto the bracket
      Lock position switch installation
  2. Install the keylock switch with cable to the node.
    1. Hook the keylock switch onto the pin on the sidewall of the node; then, slightly push it leftward.
    2. Tighten the screw to secure the keylock switch.
    3. Connect the keylock switch cable to the system board.
    Figure 2. Installation of a keylock switch with cable
    Lock position switch installation

 

After this task is completed