Skip to main content

Install a MicroSD card

Follow instructions in this section to install a MicroSD card.

About this task

To avoid potential danger, make sure to read and follow the safety information.

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the node; then, remove it from the package and place it on a static-protective surface.

Note

  • Depending on the specific configuration, the node or security bezel might look different from the illustrations in this section.

Procedure

  1. Make preparations for this task.
    1. Make sure that the drive cage has not been installed yet.
    2. Locate the MicroSD card socket on the system board (see System-board connectors).
  2. Install the MicroSD card.
    1. Place the MicroSD card into the socket.
    2. Close the socket lid.
    3. Slide the socket lid to the lock position.
      Figure 1. Installation of a MicroSD card
      MicroSD card installation

　

After this task is completed

　

Demo video

Watch the procedure on YouTube