Skip to main content

Install the rubber feet

Follow instructions in this section to install the rubber feet (four rubber pads) to a node or node sleeve.

About this task

To avoid potential danger, make sure to read and follow the safety information.

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

Procedure

  1. Carefully place the node or node sleeve upside down.
  2. Remove the film on the rubber pad; then, stick the rubber pad onto the corner of the underside of the nodeor node sleeve .
    Figure 1. Installation of a rubber pad
    Installing the rubber feet
  3. (Optional) If necessary, repeat the same step for the other three rubber feet.

　

After this task is completed

　

Demo video

Watch the procedure on YouTube