Remove the rubber feet
Follow instructions in this section to remove the rubber feet (four rubber pads) from a node or node sleeve.
About this task
To avoid potential danger, make sure to read and follow the safety information.
- S002
CAUTIONThe power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.
Remove the shipping bracket or security bezel, if applicable (see Configuration guide); then, power off the server and disconnect the power cords (see Power off the server).
Lay the node or node sleeve on a flat, static-protective surface.
NoteFor the removal of a node from an enclosure or a node sleeve, or the removal of a node sleeve from a DIN rail or wall mount, see Configuration guide.
Procedure
- Remove a rubber pad by pulling it from the node or node sleeve.Figure 1. Removal of a rubber pad
After this task is completed
- If necessary, install a replacement unit (see Install the rubber feet).
- If you are instructed to return the component, follow all of the packaging instructions and use any packaging materials for shipping that are supplied to you.
Give documentation feedback