Install the front I/O module (3.5-inch drive model)

Use this information to install the front I/O module (3.5-inch drive model).

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
If the server is installed in a rack, remove the server from the rack.

Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Go to Drivers and Software download website for ThinkSystem SR250 V3 to see the latest firmware and driver updates for your server.
Go to Update the firmware for more information on firmware updating tools.

Procedure

Slide the front I/O module and cables into the slot on the front server.
Figure 1. Front I/O module installation
Install the two screws that secure the front I/O module.
Figure 2. Front I/O module installation

After you finish

Connect the front I/O module cables to the system board. See Front I/O module cable routing.
Install the top cover. See Install the top cover.
Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube

Give documentation feedback