Install the 2.5-inch backplane

Use this information to install the 2.5-inch backplane.

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

• If the server is installed in a rack, remove the server from the rack.

Note

Depending on the configuration, the following illustration might differ slightly from your backplane.

Firmware and driver download: You might need to update the firmware or driver after replacing a component.

• Go to Drivers and Software download website for ThinkSystem SR250 V3 to see the latest firmware and driver updates for your server.

• Go to Update the firmware for more information on firmware updating tools.

Procedure

1. Align the two pins on the backplane with the corresponding holes in the chassis.
2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the backplane is fully seated in place.
   Figure 1. Ten 2.5-inch hot-swap drive backplane installation
   
   

   1 Pins

   2 Corresponding holes

   Figure 2. Eight 2.5-inch hot-swap drive backplane installation
   
   

   1 Pin

   2 Corresponding holes