Skip to main content

Install the 3.5-inch backplate

Use this information to install the 3.5-inch backplate.

About this task

Attention

Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
If the server is installed in a rack, remove the server from the rack.

Note

Depending on the configuration, the following illustration might differ slightly from your backplate.

Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Go to Drivers and Software download website for ThinkSystem SR250 V3 to see the latest firmware and driver updates for your server.
Go to Update the firmware for more information on firmware updating tools.

Procedure

Install the backplate.

Insert the backplate into the chassis at an angle. Make sure the pins are against the backplate on the backside.
Rotate the backplate up towards the front of the server.
Close the retaining clips to secure the backplate in place.
Figure 1. Backplate installation

1 Pin

After you finish

Connect the backplate cables to the system board or RAID adapter. See Backplane and backplate cable routing.
Install the top cover. See Install the top cover.
Install drives and drive bay fillers into the drive bays. See Install a hot-swap drive.
Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube

Give documentation feedback