Skip to main content

Install the RAID flash power module on the chassis

Use this information to install the RAID flash power module on the chassis.

About this task

Attention

  • Read Installation guidelines to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Touch the static-protective package that contains the RAID flash power module to any unpainted surface on the outside of the server. Then, take the RAID flash power module out of the package and place it on a static-protective surface.
  2. If the server comes with a tray that covers the place of the RAID flash power module on the chassis, remove it first.
    1. Press the blue touch point to release the latch.
    2. Slide the tray as depicted below and lift the tray out of the chassis.
    Figure 1. Tray removal
    Tray removal

  3. If the server does not have a RAID flash power module holder on the chassis, install one first.
    Figure 2. RAID flash power module holder installation
    RAID flash power module holder installation

  4. Install the RAID flash power module on the chassis.
    Figure 3. Installation of the RAID flash power module on the chassis
    Installation of the RAID flash power module on the chassis

    1. Open the retention clip on the holder.
    2. Put the RAID flash power module into the holder and press it down to secure it into the holder.

After you finish

  1. Connect the super capacitor module to an adapter with the extension cable that comes with the flash power module. See RAID flash power modules.

  2. Complete the parts replacement. See Complete the parts replacement.