Summary of the technical specifications of the server. Depending on the model, some features might not be available, or some specifications might not apply. The latest specifications information is always available at Lenovo Press website.
Lenovo XClarity Controller (XCC), which provides service processor control and monitoring functions, video controller, and remote keyboard, video, mouse, and remote drive capabilities.
The server supports Lenovo XClarity Controller 2 (XCC2). For additional information about Lenovo XClarity Controller 2 (XCC2), refer to Lenovo XClarity Controller portal page.
Front connectors:
(Optional) One VGA connector
(Optional) One USB 3.1 Gen 1 (5 Gbps) connector
(Optional) One USB 2.0 connector
(Optional) One external diagnostics connector
Note
These connectors are available only when the front I/O module is installed in the server.
Rear connectors:
One VGA connector
Three USB 3.1 Gen 1 (5 Gbps) connectors
One XCC system management port (10/100/1000 Mbps RJ-45) to connect to a systems-management network. This RJ-45 connector is dedicated to the Lenovo XClarity Controller functions.
Two or four Ethernet connectors on the OCP module (optional)
(Optional) One serial port connector
Note
This connector is available when the serial port cable is installed in the server.
Network
OCP module
Note
The OCP module is an optional part. It is default to be installed on the rear and optional in the front of the server.
If the ThinkSystem V3 Management NIC Adapter Kit is installed on the server, it will not be displayed on the PCIe card list of system management software, such as XCC, LXPM, and so on.
Supports up to seven dual-rotor hot-swap fans (including one redundant fan rotor)
Supports the following two fan types:
Standard fan 4056 (speed: 21000 RPM)
Performance fan 4056 (speed: 28000 RPM)
Note
When the system is powered off but still plugged in to AC power, fans 1 and 2 may continue to spin at a much lower speed. This is the system design to provide proper cooling.
The server supports up to two power supplies for redundancy.
Table 1. Electrical input for power supply units
Power supply
100-127 V ac
200-240 V ac
240 V dc
-48 V dc
750-watt 80 PLUS Platinum
√
√
√
750-watt 80 PLUS Titanium
√
√
1100-watt 80 PLUS Titanium
√
√
√
1100-watt 80 PLUS Platinum
√
√
1800-watt 80 PLUS Platinum
√
√
1800-watt 80 PLUS Titanium
√
√
1100-watt -48V DC
√
CAUTION
240 V dc input (input range: 180-300 V dc) is supported in Chinese Mainland ONLY.
Power supply with 240 V dc input cannot support hot plugging power cord function. Before removing the power supply with dc input, turn off server or disconnect dc power sources at the breaker panel or by turning off the power source. Then, remove the power cord.
Minimal configuration for debugging
One processor
One memory module in slot 7
One power supply
One HDD/SSD drive or one M.2 drive (if OS is needed for debugging)