System board jumpers
The following illustration shows the location of the jumpers on the system board of your server.
- Before you move any jumpers, turn off the server; then, disconnect all power cords and external cables. Do not open your server or attempt any repair before reading and understanding the following information:
- Any system-board switch or jumper block that is not shown in the illustrations in this document are reserved.
Figure 1. System board jumpers
|Jumper name||Jumper number||Jumper setting|
|1 Clear CMOS jumper||J3|
|2 Enable FPGA flash jumper||J11|
|3 Clear password jumper1||J6|
|4 Recover BIOS/UEFI jumper||J5|
|5 BMC loads to default jumper||J9|
1The jumper is used for clearing the UEFI password. After clearing the UEFI password, you can boot into setup to set a new password.