Install the front I/O module

Follow instructions in this section to install the front I/O module.

About this task

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Watch the procedure

• A video of this procedure is available at YouTube.

Procedure

1. Touch the static-protective package that contains the new part to any unpainted surface on the outside of the server. Then, take the new part out of the package and place it on a static-protective surface.
2. Install the front I/O module.
   Figure 1. Installing the front I/O module
   
   
   1. Insert the front I/O module into the front chassis.
   2. Install the screw to secure the front I/O module in place.

After you finish

1. Connect the cables of the front I/O module to the processor board. See Internal cable routing.

2. Complete the parts replacement. See Complete the parts replacement.