Skip to main content

Install a 7mm drive

Follow the instructions in this section to install a 7mm drive.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • To make sure that there is adequate system cooling, do not operate the server for more than two minutes without either a drive or a drive bay filler installed in each bay.

  • Before you make changes to drives, drive controllers (including controllers that are integrated on the system board assembly), drive backplanes, or drive cables, back up all important data that is stored on drives.

  • Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration information.

Note

For a complete list of supported optional device for this server, see Lenovo ServerProven website.

Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Procedure

  1. If a drive filler has been installed in the drive bay, remove it.
    Figure 1. Removing 7mm drive fillers

  2. Gently rotate the release latch away to unlock the drive handle.
  3. Slide the drive into the drive bay, and push it until it stops; then, rotate the handle back to the locked position.
    Figure 2. Installing 7mm drives

    1. Ensure that the tray handle is in the open position. Slide the drive into the drive bay, and push it until it stops.
    2. Rotate the handle back to the locked position.

After you finish

  1. Check the drive status LED to verify if the drive is operating correctly.
    • If the yellow LED is lit continuously, it is malfunctioning and must be replaced.
    • If the green LED is flashing, the drive is functioning.
    Note
    If the server is configured for RAID operation through a ThinkSystem RAID adapter, you might have to reconfigure your disk arrays after you install drives. See the ThinkSystem RAID adapter documentation for additional information about RAID operation and complete instructions for using ThinkSystem RAID adapter.

  2. If any of the drive bays are left empty, fill them with drive bay fillers.

Demo video

Watch the procedure on YouTube