Skip to main content

Install the riser bracket for slot 14 to 15 (riser 2)

The riser bracket for slot 14 to 15 is attached to the slot 10 to 15 I/O tray riser that is accessed from the rear of the server. After removing the I/O tray and the riser for slot 10 to 15 (riser 2), slide the bracket onto the riser until the retaining clips engage.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Before you install the riser bracket, make sure that there is no filler installed on the I/O tray for slot 14 to 15.

Complete the following steps to install the riser bracket.

Figure 1. Riser bracket installation (slot 14 to 15)
Riser bracket for slot 14 to 15 installation

Align the slots on the riser bracket with the pins on the riser and slide it in place; then, press the bracket onto the riser until the retaining clips engage.

If you have no other operations to perform on the riser after installing an adapter in slot 10 to 15:

  1. Install adapters in the riser. See Install a PCIe adapter in slot 10 to 15.

  2. If any of the adapters in the riser have internal cables, make sure that they are connected before installing the riser in the I/O tray.

  3. Install the riser in the I/O tray. See Install the riser for slot 10 to 15 (riser 2).

  4. Install the I/O tray in the chassis and connect all cables. See Install the I/O tray.