Skip to main content

Power supply replacement

Use the following procedures to remove and install power supplies and power supply fillers. Power supplies are at the rear of the server.

  • Remove a power supply
    Press the release latch and pull the drive to remove it from the drive bay. Power supplies are hot-swap devices that can be removed while the server is powered on.
  • Install a power supply
    Insert the power supply in its bay and press it in until the release tab locks. Power supplies are hot-swap devices that can be installed while the server is powered on.
  • Remove a power supply filler
    Remove a power supply filler by pulling the filler from the bay.
  • Install a power supply filler
    Insert the power supply filler in the bay and press it in place.