Skip to main content

Install the storage tray (fully removed)

Install the storage tray when it is fully removed by inserting it in the front of the chassis, pushing it in until it stops, and closing the release levers.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Before you install an optional storage tray:

  1. Make sure that all cables, adapters, and other components are installed and seated correctly and that you have not left loose tools or parts inside the server.

  2. Make sure that all internal cables are correctly routed. See Internal cable routing.

Complete the following steps to install a storage tray when it is fully removed from the chassis:

Figure 1. Storage tray installation (fully removed)
Install the storage tray

  1. Align the storage tray with its opening in the upper bay at the front of the chassis and insert.
  2. Fully open the storage tray release levers and push the tray into the chassis until it stops.
  3. Rotate the storage tray release levers until they lock, fully closed.

If you are done performing installation or maintenance procedures at the front of the chassis, install the front cover. See Install the front cover.

Demo video

Watch the procedure on YouTube