Parts list

Use the parts list to identify each of the components that are available for your server.

For more information about ordering the parts shown in Figure 1:

Note

Depending on the model, your server might look slightly different from the illustration.

Figure 1. Server components
Parts list

The parts listed in the following table are identified as one of the following:

Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.
Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.
Consumable and Structural parts: Purchase and replacement of consumable and structural parts is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

Table 1. Parts listing
Index	Description	Tier 1 CRU	Tier 2 CRU	FRU	Consumable and Structural parts
For more information about ordering the parts shown in Figure 1: Parts list
`1`	Fixed power supply	√
`2`	Hot-swap power supply	√
`3`	Hot-swap power supply filler				√
`4`	Power distribution board for fixed power supply				√
`5`	Power distribution board for hot-swap power supplies		√
`6`	Heat sink and fan			√
`7`	Processor			√
`8`	System board		√
`9`	Front system fan	√
`10`	5.25-inch LTO/RDX tape drive	√
`11`	5.25-inch optical disk drive			√
`12`	Front panel board assembly	√
`13`	Drive cage cover		√
`14`	Drive cage filler				√
`15`	2.5-inch drive cage	√
`16`	2.5-inch drive filler	√
`17`	2.5-inch drive	√
`18`	2.5-inch hot-swap drive backplane		√
`19`	Front door	√
`20`	2.5-inch to 3.5-inch drive adapter	√
`21`	3.5-inch drive filler	√
`22`	3.5-inch drive	√
`23`	3.5-inch hot-swap drive backplane		√
`24`	3.5-inch simple-swap drive backplate			√
`25`	3.5-inch simple-swap drive backplate with ODD			√
`26`	3.5-inch drive cage			√
`27`	PCIe adapter	√
`28`	Rear system fan	√
`29`	RAID flash power module holder				√
`30`	RAID flash power module	√
`31`	Chassis	√
`32`	Memory module	√
`33`	Intrusion switch		√
`34`	CMOS battery (CR2032)				√
`35`	M.2 drive	√
`36`	M.2 boot adapter		√

Give documentation feedback