Skip to main content

Install the 3.5-inch simple-swap drive backplate

Follow instructions in this section to install the 3.5-inch simple-swap drive backplate.

About this task

To avoid potential danger, read and follow the following safety statements.
  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safety.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Position the backplate on the drive cage so that the tabs on the drive cage are inserted into the corresponding slots on the backplate.
  2. Close the plunger to secure the backplate in place.
    Figure 1. Installing the simple-swap drive backplate
    Installing the simple-swap drive backplate

After you finish

  1. Reinstall the drive cage into the chassis. See Install the 3.5-inch/2.5-inch drive cage.

  2. Reinstall all the simple-swap drives and drive bay fillers (if any) into the drive cage. See Install a simple-swap drive or Install a 2.5-inch drive into a 3.5-inch drive bay.

  3. Connect the backplate cables to the system board. See Simple-swap drives cable routing.

  4. Install the system fan. See Install the front system fan.

  5. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on Youtube