Install the server to rack

Follow instructions in this section to install ST250 V3 to the rack.

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

About this task

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

Procedure

1. Unlock ST250 V3 front door.
   1. Slide and push the key into the corresponding hole on the front door and turn it clockwise to unlock the door.
   2. Open the front door.
   
   
   
2. Lift the front door to detach the hinge, and remove it from the server.
   
   
   
3. Install the two brackets as illustrated.
   
   
   
4. Install the four rubber safety pads as illustrated.
   
   
   
5. Remove the four screws and feet from the server.
   
   
   
6. Align the server with the brackets and the tab on the front of the tray; then, gently place the server on the tray.
   
   
   

   CAUTION

   Use safe practices when lifting the server.

   
   
   
7. Install the server into the rack cabinet.
   1. Lift the rail latches on both sides.
   2. Gently slide and push the tray into the rack cabinet.
   CAUTION

   To avoid hurting yourself, keep your hands from the latch area when the latches approach the outer rail.

   
   
   
8. Secure the tray with two M6 x 16 screws to the front of the rack cabinet.