Remove the server from rack
Follow instructions in this section to remove ST250 V3 from the rack.
S002
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
About this task
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
Procedure
Note
Your system might look slightly different from those shown in the illustrations.
- Remove the two M6 x 16 screws on the front of the rack cabinet.
- Remove the server from the rails.
Slide and pull the rack server tray out of the rack cabinet.
Lift the server out of the tray.
CAUTIONUse safe practices when lifting the server.
After you finish
Place the server on its side with the cover up.
To install the server to the rails, see Install the server to rack.
Demo video
Give documentation feedback