Skip to main content

Removing a 1.8-inch hard disk drive

Use this information to remove a 1.8-inch hard disk drive.

Attention
Static electricity that is released to internal server components when the server is powered-on might cause the server to halt, which might result in the loss of data. To avoid this potential problem, always use an electrostatic-discharge wrist strap or other grounding system when you work inside the server with the power on.

To remove a 1.8-inch hard disk drive, complete the following steps.

  1. Read Safety and Installation guidelines.
  2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see Removing a compute node from a chassis for instructions).
  3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.
  4. Remove the cover (see Removing the compute node cover).
  5. Pull the plunger of the 1.8-inch hard disk drive cage outward and rotate the cage upward.
    Figure 1. Lift the 1.8-inch hard disk drive cage upward
    Lift the 1.8-inch hard disk drive cage upward
  6. Push the release latch outward to release the drive handle.
    Figure 2. 1.8-inch hard disk drive removal
    1.8-inch hard disk drive removal
  7. Unlatch the drive handle.
    Figure 3. 1.8-inch hard disk drive removal
    1.8-inch hard disk drive removal
  8. Then, pull the drive out of the drive bay.
    Figure 4. 1.8-inch hard disk drive removal
    1.8-inch hard disk drive removal
  9. Close the cage handle into position.
  10. Pull the plunger of the 1.8-inch hard disk drive cage outward and rotate the cage downward until the cage snaps into place.
    Figure 5. Put the 1.8-inch hard disk drive cage downward
    Put the 1.8-inch hard disk drive cage downward

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.