Skip to main content

Install a front operator assembly

Follow instructions in this section to install a front operator assembly.

About this task

To avoid potential danger, make sure to read and follow the safety information.

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
  • Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the node; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Align the front operator assembly with the front and side edges of the node; then, place the front operator assembly into its slot in the node.
  2. Tighten the three screws to secure the front operator assembly to the node.
    Figure 1. Installation of the front operator assembly
    front operator assembly screws

 

After this task is completed