Remove the front operator assembly

Follow instructions in this section to remove the front operator assembly.

About this task

To avoid potential danger, make sure to read and follow the safety information.

S002

CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.
Remove the shipping bracket or security bezel, if applicable (see Configuration guide); then, power off the server and disconnect the power cords (see Power off the server).
Remove the node from the enclosure or node sleeve, if applicable (see Configuration guide); then, carefully lay the node on a flat, static-protective surface.

Procedure

Make preparations for this task.
1. If applicable, unlock or remove any locking device that secures the top cover, such as a Kensington lock; then, remove the top cover (see Remove the top cover).
2. Disconnect the cable from the front operator assembly (see Cable routing for the front operator assembly).
Remove the three screws that secure the front operator assembly to the node.
Disengage and remove the front operator assembly from its slot.
Figure 1. Removal of the front operator assembly

After this task is completed

Install a replacement unit (see Install a front operator assembly).
If you are instructed to return the component, follow all of the packaging instructions and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube

Give documentation feedback