Skip to main content

Remove the intrusion switch with cable

Follow instructions in this section to remove the intrusion switch with cable.

About this task

To avoid potential danger, make sure to read and follow the safety information.

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

Procedure

  1. Make preparations for this task.
    1. If applicable, unlock or remove any locking device that secures the top cover, such as a Kensington lock; then, remove the top cover (see Remove the top cover).
    2. Remove the air baffle (see Remove the air baffle).
  2. Remove the intrusion switch with cable from the node
    1. Remove the screw that secures the intrusion switch to the sidewall of the node.
    2. Tilt the intrusion switch and remove it from the node.
    3. Disconnect the intrusion switch cable from the connector on the system board.
      Figure 1. Removal of the intrusion switch with cable from the node
      Intrusion switch removal
  3. (Optional) If necessary, remove the intrusion switch with cable from the intrusion switch holder.
    1. Press the latches of the intrusion switch to release it from the holder.
    2. Separate the intrusion switch with cable from the holder.
      Figure 2. Separation of the intrusion switch from the holder
      Intrusion switch removal from the holder

　

After this task is completed

  • Install a replacement unit (see Install an intrusion switch with cable).
  • If you are instructed to return the component, follow all of the packaging instructions and use any packaging materials for shipping that are supplied to you.

　

Demo video

Watch the procedure on YouTube