Install the internal drive cage

Follow instructions in this section to install the internal drive cage.

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

About this task

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

Procedure

1. To avoid interfering the internal drive cage, route the cables for internal drive backplane to the cable clip on the processor air baffle to fix the cables.
   Figure 1. Internal backplane cables on cable clip
   
   
2. Install the internal drive cage.
   1. Align the internal drive cage with the guide pins on the chassis; then, lower the internal drive cage down.
      Note

      Make sure the cables of PCIe riser 2 and front drive backplane are not covered by the internal drive cage.
   2. Fasten the four captive screws to secure the internal drive cage.
   Figure 2. Installing the internal drive cage