Skip to main content

Install the M.2 backplane

Follow instructions in this section to install the M.2 backplane.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

Install the M.2 backplane to the tray.
  1. Align the notch of the M.2 backplane with the guide pin on the tray; then, insert the backplane at an angle.
  2. Lower down the connector side of the M.2 backplane to the tray.
Figure 1. Installing the M.2 backplane

  1. Fasten the captive screw on the M.2 backplane.
  2. Fasten one screw to secure the M.2 backplane.
Figure 2. Installing the M.2 backplane

After this task is completed

  1. If necessary, install the M.2 drives. See Install an M.2 drive.

  2. Proceed to install the M.2 backplane assembly. See Install the M.2 backplane assembly.

  3. Complete the parts replacement. See Complete the parts replacement.

Demo Video

Watch the procedure on YouTube