Remove the M.2 backplane

Follow instructions in this section to remove the M.2 backplane.

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

About this task

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• If applicable, remove the security bezel. See Remove the security bezel.

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

• If the server is installed in a rack, remove the server from the rack. See Remove the server from the rack.

Procedure

1. Make preparation for this task.
   1. Remove the top cover. See Remove the top cover.
   2. Remove the M.2 backplane assembly. See Remove the M.2 backplane assembly.
   1. If necessary, remove the M.2 drives. See Remove an M.2 drive.
2. Remove the M.2 backplane from the tray.
   1. Loosen the screw that secures the M.2 backplane.
   2. Loosen the captive screw on the M.2 backplane.
   Figure 1. Removing the M.2 backplane
   
   
   1. Lift the connector side of the M.2 backplane up at an angle.
   2. Remove the M.2 backplane
   Figure 2. Removing the M.2 backplane