Skip to main content

Install the flash power module

Use this information to install the flash power module.

To avoid possible danger, read and follow the following safety information.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S004
Attention
CAUTION

When replacing the lithium battery, use only Lenovo specified part number or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:
  • Throw or immerse into water
  • Heat to more than 100°C (212°F)
  • Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

Before you install the flash power module, complete the following steps:
  1. Read the following section(s) to ensure that you work safely.

To install the flash power module, complete the following steps:

Figure 1. Flash power module installation
Flash power module installation
  1. Insert the end of the flash power module into its carrier.
  2. Rotate the flash power module down into the carrier until the tab clicks in place to secure it.

After you install the flash power module, complete the following steps:

  1. Connect the required cable and make sure that all cables are correctly routed.

  2. Install the top cover onto the server (see Install the top cover).

  3. Install the server into the rack if necessary.

  4. Reconnect power cords and all external cables.

Demo video

Watch the procedure on YouTube