Skip to main content

Install the VGA cable (2.5-inch HDD model)

Use this information to install the VGA cable for the 2.5-inch HDD model.

  1. Read the following section(s) to ensure that you work safely.
  2. Turn off the server. Disconnect the power cords and all external cables (see Power off the server).

  3. If server is installed in a rack, remove the server from the rack.

  4. Remove the top cover (see Remove the top cover).

  5. Remove the front I/O assembly (see Remove the front operator panel (2.5-inch HDD model)).

To install the VGA cable, complete the following steps:

Insert the VGA cable into the front I/O assembly; then; install and fasten two screws to secure the VGA cable.
Figure 1. VGA cable installation
VGA cable installation

After you install the VGA cable, complete the following steps:

  1. Reinstall the front I/O assembly (see Install the front operator panel (2.5-inch HDD model)).

  2. Reinstall the air baffle if it was removed (see Install the air baffle).

  3. Install the top cover onto the server (see Install the top cover).

  4. Install the server into the rack if necessary.

  5. Reconnect power cords and all external cables.

Demo video

Watch the procedure on YouTube