Install the hot-swap drive backplane
Use this information to install the hot-swap drive backplane.
Before you install the 3.5-inch hot-swap drive backplane, complete the following steps:
- Read the following section(s) to ensure that you work safely.
Note
Depending on the configuration, the following illustration might differ slightly from your backplane.
If the 95 W processor is used, the server does not support the ten 2.5-inch hot-swap drive backplane.
To install the hot-swap drive backplane, complete the following steps:
Figure 1. 2.5-inch hot-swap drive backplane installation
| 1 Pin | 2 Corresponding holes |
Figure 2. 3.5-inch hot-swap drive backplane installation
| 1 Pin | 2 Corresponding holes |
- Align the two pins on the backplane with the corresponding holes in the chassis.
- Lower the backplane into the chassis. Ensure that the pins pass through the holes and the backplane is fully seated in place.
After you install the hot-swap drive backplane, complete the following steps:
Connect the backplane cables to the backplane. See Internal cable routing for more information.
Reinstall all the drives and drive fillers into the drive bays (see Install a hot-swap drive).
Install the top cover onto the server (see Install the top cover).
Install the server into the rack if necessary.
Reconnect power cords and all external cables.
Demo video
Give documentation feedback