Skip to main content

Adjust the retainer on the M.2 backplane

Use this information to adjust the retainer on the M.2 backplane.

About this task
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding systems.

Procedure

Note

The M.2 backplane you want to adjust might be different from the following illustrations, but the adjustment method is the same.

Figure 1. M.2 retainer adjustment
Adjust the M.2 retainer.

  1. Press both sides of the retainers.
  2. Move the retainer forward until it is in the large opening of the keyhole.
  3. Take the retainer out of the keyhole.
  4. Insert the retainer into the correct keyhole into which the retainer should be installed to accommodate the particular size of the M.2 drive you wish to install.
  5. Press both sides of the retainer.
  6. Slide the retainer backwards until it is seated in place.

After you finish

Complete the parts replacement. See Complete the parts replacement.