Install a rear riser card
Use this information to install a rear riser card.
About this task
For more riser brackets supported, see Rear riser card replacement.
The riser assembly you want to install might be different from the following illustrations, but the installation method is the same. The following takes the LP-FH riser assembly as an example.
Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding systems.
- Touch the static-protective package that contains the riser card to any unpainted surface on the outside of the server. Then, take the riser card out of the package and place it on a static-protective surface.
- Install the riser card and secure it to the bracket.Figure 1. Riser card installation
Align the screw holes in the riser card with the corresponding ones in the bracket.
Install the two screws to secure the riser card to the bracket.
- If necessary, reinstall the PCIe adapters on the riser card. See Install a PCIe adapter. Then, refer to your note to reconnect any cables of the PCIe adapters on the riser card. Or you can refer to the Internal cable routing and locate the cable routing information for your configuration options.
- Position the riser assembly on the chassis. Align the plastic clip and two pins on the bracket with the guide pin and two holes on the chassis, and align the riser card with the riser slot on the system board assembly. Then, carefully press the riser assembly straight down into the slot until it is fully seated.Figure 2. Riser assembly installation