Processor NeptuneTM Air Module
Use this section to understand the cable routing of the Processor NeptuneTM Air Module (NeptAir).
For the locations of the NeptAir module connectors on the processor board, see System-board-assembly connectors for details.
The two pump cables and one cable for the leakage detection sensor module are integrated to the NeptAir module, make sure that all three cables are connected.
Note
For better cable arrangement, it is required to install the leakage detection sensor module to a designated holder, and make sure that the module is secured in holder clips. Use the illustration below or Install the Lenovo Processor NeptuneTM Air Module for details.
Figure 1. NeptAir module cable routing
| From | To |
|---|---|
| 1 Pump 1 | 1 Pump 1 connector |
| 2 Pump 2 | 2 Pump 2 connector |
| 3 Leak detection cable | 3 Rear leak detection connector |
Give documentation feedback