Skip to main content

Parts list

Use the parts list to identify each of the components that are available for your server.

For more information about ordering the parts shown in Figure 1, go to:

Parts list

Note
Depending on the model, your server might look slightly different from the illustration. Some of the components might not be available on your server.
Figure 1. Server components
Graphic showing all parts associated with the server

The parts listed in the following table are identified as one of the following:
  • Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.

  • Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.

  • Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.

  • Consumable and Structural parts: Purchase and replacement of consumable and structural parts (components, such as a cover or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

Table 1. Parts list
IndexDescriptionTier 1 CRUTier 2 CRUFRUConsumable and Structural parts

For more information about ordering the parts shown in Figure 1, go to:

Parts list

It is highly recommended that you check the power summary data for your server using Lenovo Capacity Planner before purchasing any new parts.

1Top cover   
2Air baffle   
3RAID adapter on the system board   
4LOM adapter   
5Riser 1 bracket (two low-profile slots)   
6Riser 2 bracket (one low-profile slot)   
7Riser 1 bracket (one low-profile slot and one full-height half-length slot)   
8Serial port module   
9Riser card   
10TCM/TPM adapter (only available in Chinese Mainland)   
11System board   
12M.2 retainer   
13M.2 drive backplane   
14M.2 drive   
15RAID super capacitor module   
16RAID super capacitor module holder   
17Rear hot-swap drive cage   
18Rear backplane   
19Power supply   
20Power supply filler   
21Chassis with four 3.5-inch drive baysChassis with eight 2.5-inch drive baysChassis with ten 2.5-inch drive bays   
22PCIe adapter   
23Security bezel   
24Front I/O assembly for server models with four 3.5-inch drive bays   
25Front I/O assembly for server models with eight 2.5-inch drive bays   
26Front I/O assembly for server models with ten 2.5-inch drive bays   
272.5-inch drive filler   
282.5-inch hot-swap drive   
293.5-inch drive filler   
303.5-inch hot-swap drive   
31System fan   
32CMOS battery   
33Backplane for server models with ten 2.5-inch drive bays   
34Backplane for server models with eight 2.5-inch drive bays   
35Backplane for server models with four 3.5-inch drive bays   
36Memory module (DCPMM module might look slightly different from the illustration.)   
37Processor   
38Heat sink