Skip to main content

Install a memory module

Follow instructions in this section to install a memory module.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Make sure to remove or install memory module 20 seconds after disconnecting power cords from the system. It allows the system to be completely discharged of electricity and safe for handling memory module.

  • Make sure to adopt one of the supported configurations listed in Memory module installation rules and order.

  • Memory modules are sensitive to static discharge and require special handling. Refer to the standard guidelines at Handling static-sensitive devices:

    • Always wear an electrostatic-discharge strap when removing or installing memory modules. Electrostatic-discharge gloves can also be used.

    • Never hold two or more memory modules together so that they do not touch each other. Do not stack memory modules directly on top of each other during storage.

    • Never touch the gold memory module connector contacts or allow these contacts to touch the outside of the memory module connector housing.

    • Handle memory modules with care: never bend, twist, or drop a memory module.

    • Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid metals may damage the memory modules.

    • Do not insert memory modules while holding packages or passive components, which can cause package cracks or detachment of passive components by the high insertion force.

Important
Remove or install memory modules for one processor at a time.
Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Procedure

Attention

Make sure to remove or install memory module 20 seconds after disconnecting power cords from the system. It allows the system to be completely discharged of electricity and safe for handling memory module.

  1. Touch the static-protective package that contains the memory module to any unpainted surface on the outside of the server. Then, take the memory module out of the package and place it on a static-protective surface.
  2. Locate the required memory module slot on the system board.
    Note

    Ensure that you observe the installation rules and sequence in Memory module installation rules and order.

  3. Install the memory module into the slot.
    Figure 1. Memory module installation
    Memory module installation

    1. Open the retaining clip on each end of the memory module slot.
      Attention
      To avoid breaking the retaining clips or damaging the memory module slots, open and close the clips gently.
    2. Align the memory module with the slot, and gently place the memory module on the slot with both hands.
    3. Firmly press both ends of the memory module straight down into the slot until the retaining clips snap into the locked position.
      Note
      If there is a gap between the memory module and the retaining clips, the memory module has not been correctly inserted. In this case, open the retaining clips, remove the memory module, and then reinsert it.

After you finish

Demo video

Watch the procedure on YouTube