Skip to main content

Install the 2.5-inch rear drive assembly

Use this information to install the 2.5-inch rear drive assembly.

About this task

The following illustrates how to install the 2.5-inch rear drive assembly.

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Touch the static-protective package that contains the rear drive cage to any unpainted surface on the outside of the server. And then, take the rear drive cage out of the package and place it on a static-protective surface.
  2. Gently press and hold the tab on the rear drive cage as shown and remove the air baffle from the rear drive cage.
    Figure 1. Air baffle removal
    Air baffle removal

    1. Press the tab on one side to disengage the air baffle.
    2. Lift the air baffle to remove it from drive cage.
  3. Align the rear backplane with the rear drive cage and lower it into the rear drive cage.
    Figure 2. Rear backplane installation
    Rear backplane installation

  4. Connect the cables to the backplane.
  5. Install the air baffle into the rear drive cage as shown.
    Figure 3. Air baffle installation
    Air baffle installation

    1. Align the air baffle edge with the notch on the drive cage.
    2. Press the air baffle down and make sure that it is seated in place.
  6. Align the pins on the rear drive cage with the corresponding hole and slot in the chassis. Then, lower the rear drive cage into the chassis until it is fully seated.
    Figure 4. Hot-swap rear drive cage installation
    Hot-swap rear drive cage installation

  7. Connect the cables to the system board or expansion slots. See Internal cable routing.
After you finish

  1. Reinstall the drives or drive fillers into the rear drive cage. See Install a 2.5-inch hot-swap drive.

  2. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube