Skip to main content

Remove the RAID flash power module on the riser assembly

Use this information to remove the RAID flash power module on the riser assembly.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Remove the top cover. See Remove the top cover.
  2. Disconnect the cable of the RAID flash power module.
  3. Remove the riser assembly. See Remove a rear riser card.
  4. Remove the RAID flash power module from the riser assembly.
    Figure 1. Removal of the RAID flash power module from the riser assembly
    Removal of the RAID flash power module from the riser assembly

    1. Rotate the latch on the riser bracket to the open position.
    2. Remove the RAID flash power assembly from the riser assembly.
    3. Open the retention clip on the holder of the RAID flash power module.
    4. Take the RAID flash power module out of the holder.

After you finish

If you are instructed to return the old RAID flash power module, follow all packaging instructions and use any packaging materials that are provided.

Demo video

Watch the procedure on YouTube