Skip to main content

Remove a RAID flash power module from the middle drive cage

Follow the instructions in this section to remove a RAID flash power module from the 2.5-inch middle drive cage.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration information.

Procedure

  1. Make preparation for the task.
    1. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover, or remove the server from the rack. See Server replacement.
    2. Remove the top cover. See Remove the top cover.
  2. Open the drive cage handle.
    Figure 1. Opening the handle of the middle drive cage
    Opening the handle of the middle drive cage
  3. Remove the rubber on the cover of the holder.
    Figure 2. Removing the rubber
    Removing the rubber
  4. Remove the RAID flash power module.
    Figure 3. Removing the RAID flash power module from the middle drive cage
    Removing the RAID flash power module from the middle drive cage
    1. Pull out the blue latch on the cover.
    2. Slide the cover out of the holder, and disconnect the cable of the RAID flash power module.
    3. Take the RAID flash power module out of the holder.

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube