Install the front I/O assembly
Use this information to install the front I/O assembly.
Note
The following procedure is based on the scenario that you are installing the front I/O assembly for the server model with eight 3.5-inch front drive bays. For server models with 2.5-inch front drive bays or twelve 3.5-inch front drive bays, the front I/O assembly is assembled with the right rack latch. See Install the rack latches for the installation procedures.
Before installing the front I/O assembly, touch the static-protective package that contains the new front I/O assembly to any unpainted surface on the outside of the server. Then, take the new front I/O assembly out of the package and place it on a static-protective surface.
To install the front I/O assembly, complete the following steps:
Figure 1. Front I/O assembly installation
- Insert the front I/O assembly into the assembly bay.
- Install the screws to secure the front I/O assembly in place.
After installing the front I/O assembly:
Connect the cables of the front I/O assembly to the system board. See Front I/O assembly.
Complete the parts replacement. See Complete the parts replacement.
Demo video
Give documentation feedback