Remove a hot-swap drive

Use this information to remove a hot-swap drive.

Read the installation Guidelines

ATTENTION: Static Sensitive Device Ground package before opening

Before removing a hot-swap drive:

1. Ensure that you have back up data on your drive, especially if it is part of a RAID array.

   • Before you make changes to drives, RAID adapters, drive backplanes, or drive cables, back up all important data that is stored on the drives.

   • Before you remove any component of a RAID array, back up all RAID configuration information.

2. If one or more NVMe drives are to be removed, it is recommended to disable them first in Safely Remove Hardware and Eject Media (Windows) or filesystem (Linux). See the labels above the drive bays to determine the type of the drive to remove. If the drive bay numbers come with the term NVMe, it indicates that the installed drives are NVMe drives.

3. If the security bezel is installed, remove it. See Remove the security bezel.

Attention

To ensure that there is adequate system cooling, do not operate the server for more than two minutes without either a drive or a drive filler installed in each bay.

To remove a hot-swap drive, complete the following steps:

1. Slide the release latch to open the drive tray handle.
   Figure 1. Opening the drive tray handle of a 2.5-inch hot-swap drive
   

   

   
   
   Figure 2. Opening the drive tray handle of a 3.5-inch hot-swap drive
   

   

   
   
2. Grasp the handle and slide the drive out of the drive bay.
   Figure 3. 2.5-inch hot-swap drive removal
   

   

   
   
   Figure 4. 3.5-inch hot-swap drive removal