Remove the CMOS battery
Use this information to remove the CMOS battery.
Lenovo has designed this product with your safety in mind. The lithium CMOS battery must be handled correctly to avoid possible danger. If you replace the CMOS battery, you must adhere to the following instructions.
If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal components, be aware of the following environmental consideration. Batteries and accumulators that contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper manner.
To order replacement batteries, call 1-800-IBM-SERV within the U.S., and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your support center or business partner.NoteAfter you replace the CMOS battery, you must reconfigure the server and reset the system date and time.
- Throw or immerse into water
- Heat to more than 100°C (212°F)
- Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Remove the top cover. See Remove the top cover.
Remove any parts and disconnect any cables that might impede your access to the CMOS battery.
To remove the CMOS battery, complete the following steps:
Watch the procedure. A video of the installation and removal process is available at YouTube
- Locate the CMOS battery. See System board components.
- Press the battery clip as shown and carefully lift CMOS battery out of the socket.Attention
Figure 1. CMOS battery removal
Failing to remove the CMOS battery properly might damage the socket on the system board. Any damage to the socket might require replacing the system board.
Do not tilt or push the CMOS battery by using excessive force.
Install a new CMOS battery. See Install the CMOS battery.
Dispose of the CMOS battery as required by local ordinances or regulations.