Remove a hot-swap power supply unit

Follow the instructions in this section to remove a hot-swap power supply unit.

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

S029

DANGER

danger

For -48V dc power supply, electrical current from power cords is hazardous.

To avoid a shock hazard:

• To connect or disconnect -48V dc power cords when you need to remove/install redundancy power supply unit(s).

To Connect:

To Disconnect:

Turn OFF subject dc power source(s) and equipment(s) that are attached to this product. Install the power supply unit(s) into the system housing. Attach dc power cord(s) to the product. Ensure correct polarity of -48 V dc connections: RTN is + and -Vin (typical -48 V) dc is -. Earth ground should be connected very well. Connect dc power cord(s) to subject power source(s). Turn ON all the power source(s).

Disconnect or turn off the subject dc power source(s) (at the breaker panel) before removing the power supply unit(s). Remove the subject dc cord(s) and make sure the wire terminal of power cord(s) is insulated. Unplug the subject power supply unit(s) from the system housing.

S035

CAUTION

Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.

Procedure

1. Disconnect both ends of the power cord and keep it in an ESD-safe place.
2. Remove the power supply.
   Note

   • A CFFv4 power supply is used as an example for illustration. The replacement procedure for CRPS power supply is similar.
   • The color of the CRPS release tab might be different from the image.

   Figure 1. Removing the power supply

   
   
   
   1. Press and hold on the orange release tab.
   2. Grasp the handle and slide the power supply unit out from the server.