Skip to main content

Install a hot-swap power supply unit

Follow the instructions in this section to install a hot-swap power supply unit.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S029

DANGER
danger
For -48V dc power supply, electrical current from power cords is hazardous.

To avoid a shock hazard:

  • To connect or disconnect -48V dc power cords when you need to remove/install redundancy power supply unit(s).
To Connect:To Disconnect:
  1. Turn OFF subject dc power source(s) and equipment(s) that are attached to this product.
  2. Install the power supply unit(s) into the system housing.
  3. Attach dc power cord(s) to the product.
    • Ensure correct polarity of -48 V dc connections: RTN is + and -Vin (typical -48 V) dc is -. Earth ground should be connected very well.
  4. Connect dc power cord(s) to subject power source(s).
  5. Turn ON all the power source(s).
  1. Disconnect or turn off the subject dc power source(s) (at the breaker panel) before removing the power supply unit(s).
  2. Remove the subject dc cord(s) and make sure the wire terminal of power cord(s) is insulated.
  3. Unplug the subject power supply unit(s) from the system housing.
S035
shock hazard
CAUTION

Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.

Attention

Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

Procedure

  1. Make preparation for the task.
    1. Make sure the power supply unit to be installed is of the same wattage as the installed ones. Otherwise, complete the following steps:
      1. Turn off the server and peripheral devices.
      2. Disconnect the power cords and all external cables.
      3. Remove all the installed power supply units.
      4. Make sure all the power supply units to be installed are of the same wattage. Do not mix power supply units of different wattages in the same unit of server.
    2. If installing a power supply into an empty bay, remove the power supply filler panel from the power supply bay.
    3. If more than one units are to be installed, start with the lowest available power supply bay.
  2. Make sure the label on the power supply is facing up; then, grasp the handle and slide it into the power supply bay until it clicks into place.
    Note
    • A CFFv4 power supply is used as an example for illustration. The replacement procedure for CRPS power supply is similar.
    • The color of the CRPS release tab might be different from the image.
    Figure 1. Installing power supply unit

    Installing power supply unit

After you finish

  1. Connect the power cord to the power supply unit, and make sure it's properly connected to the power.

  2. Pull the handle to see if the power supply unit is properly installed. If it slides out, reinstall it.

  3. If the server is turned off, turn on the server. Ensure that both the power input LED and the power output LED on the power supply are lit, indicating that the power supply is operating properly.

Demo video

Watch the procedure on YouTube