Skip to main content

Install a DIMM

Use this information to install a DIMM.

See Memory module installation rules and order for detailed information about memory configuration and setup.
Attention
  • Disconnect all power cords for this task.

  • DIMMs are sensitive to static discharge and require special handling. In addition to the standard guidelines for Handling static-sensitive devices:

    • Always wear an electrostatic-discharge strap when removing or installing DIMMs. Electrostatic-discharge gloves can also be used.

    • Never hold two or more DIMMs together so that they touch. Do not stack DIMMs directly on top of each other during storage.

    • Never touch the gold DIMM connector contacts or allow these contacts to touch the outside of the DIMM connector housing.

    • Handle DIMMs with care: never bend, twist, or drop a DIMM.

Before installing a DIMM:
  1. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

  2. Ensure that you consider and follow the DIMM installation rules when performing the operation. See Memory module installation rules and order.

To install a DIMM, complete the following steps:

  1. Open the retaining clips on each end of the DIMM slot; then, install the DIMM into the slot.
    Attention
    To avoid breaking the retaining clips or damaging the DIMM slots, open and close the clips gently.
  2. Firmly press the DIMM straight down into the slot by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the slot.
    Note
    If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly inserted; open the retaining clips, remove the DIMM, and then reinsert it.
    Figure 1. DIMM installation
    DIMM installation