Skip to main content

Install a flash power module

Use this information to install a flash power module.

Before installing a flash power module:

  1. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

To install a flash power module, complete the following steps:

  1. Note the orientation of the flash power module; then, gently insert the flash power module into the bracket.
    Figure 1. Flash power module installation into bracket
    Flash power module installation into bracket
  2. Position the flash power module and bracket assembly onto the chassis, where the tabs on the bracket pass through the corresponding holes in the chassis. Move the assembly as shown until it is secured onto the chassis.
    Figure 2. Flash power module and bracket assembly installation onto chassis
    Flash power module and bracket assembly installation onto chassis
  3. Connect the flash power module cable to the RAID adapter.