Skip to main content

Removing a remotely installed RAID adapter battery/flash power module

Use this information to remove a remotely installed RAID adapter battery/flash power module.

If a RAID adapter battery / flash power module is installed near the fan cage and you need to replace it, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords.
  3. Remove the cover (see Removing the cover).
  4. Remove any cable covering or obstructing the battery/flash power module holder before opening the battery/flash power module holder.
  5. Pull the release tab toward the fan cage and unlock the retention clip.
    Figure 1. RAID adapter battery/flash power module removal
    RAID adapter battery / flash power module removal
    Attention
    Make sure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.
  6. Disconnect the battery/flash power module cable from the connector on the battery/flash power module.
  7. Lift the battery/flash power module up to remove the battery/flash power module from the holder.
  8. If you are instructed to return the RAID adapter battery/flash power module, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.