Skip to main content

Removing an optional ServeRAID upgrade adapter memory module

Use this information to remove an optional ServeRAID upgrade adapter memory module.

Before removing an optional ServeRAID upgrade adapter memory module, complete the following steps for correct configuration:

  1. Boot to webbios and delete all configurations.
  2. In controller properties of Web-bios, reset to factory defaults.
  3. Turn off AC power supply.

For more information about the MegaRAID, go to the "IBM MegaRAID support matrix".

To remove an optional ServeRAID upgrade adapter memory module, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords.
  3. Remove the cover (see Removing the cover).
  4. Disconnect the battery/flash power module cable from the battery.
    Figure 1. Disconnecting the battery cable
    Disconnecting the battery cable
    Figure 2. Disconnecting the flash power module cable
    Disconnecting the flash power module cable
  5. Remove the ServeRAID upgrade adapter memory module and the three pegs from the system board.
    Figure 3. Removing ServeRAID upgrade adapter memory module
    Removing ServeRAID upgrade adapter memory module
  6. Disconnect the battery/flash power module cable from the ServeRAID upgrade adapter memory module.
    Figure 4. Disconnecting the battery cable
    Disconnecting the battery cable
    Figure 5. Disconnecting the flash power module cable
    Disconnecting the flash power module cable
  7. If you are instructed to return the feature key, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.